The ignition circuit cut-off system will enable starting when: the transmission is in the neutral position or the transmission is in gear, the sidestand is up, and the clutch lever is pulled. To start the engine Turn the main switch on and set the engine stop switch to the run position. Confirm the indicator and … Read more
Inspect your vehicle each time you use it to make sure the vehicle is in safe operating condition. Always follow the inspection and maintenance procedures and schedules described in the Owner’s Manual. Failure to inspect or maintain the vehicle properly increases the possibility of an accident or equipment damage. Do not operate the vehicle if … Read more
This shock absorber assembly contains highly pressurized nitrogen gas. Read and understand the following information before handling the shock absorber assembly. Do not tamper with or attempt to open the cylinder assembly. Do not subject the shock absorber assembly to an open flame or other high heat source. This may cause the unit to explode … Read more
Use extra care to avoid scratching the anodized finish when making suspension adjustments. To avoid damaging the suspension’s internal mechanisms, do not attempt to turn beyond the maximum or minimum settings. YZF-R1 This model is equipped with adjustable suspension. The spring preload, rebound damping force, and compression damping force of each leg can be adjusted. … Read more
To remove the passenger seat Insert the key into the seat lock, and then turn it clockwise. Seat lock Unlock. Lift the front of the passenger seat and pull it forward. To install the passenger seat With the seat lock key still in the open position (turned clockwise), insert the projection on the rear … Read more
The CCU (communication control unit) connects to the vehicle’s CAN (controller area network) and has a GPS receiver to enable the recording of vehicle and riding data (see “Logging” on page ). Logging data and YRC setting data can be accessed when a smartphone or tablet is connected to the CCU wireless network. From the Google© … Read more
For U49 models Fuel tank overflow hose Fuel tank breather hose White mark For California Fuel tank overflow hose White mark The breather hose prevents a vacuum condition from forming within the fuel tank. The overflow hose drains excess gasoline and directs it safely away from the vehicle. Before operating the vehicle: check each hose … Read more
Make sure there is sufficient gasoline in the tank. Gasoline and gasoline vapors are extremely flammable. To avoid fires and explosions and to reduce the risk of injury when refueling, follow these instructions. Before refueling, turn off the engine and be sure that no one is sitting on the vehicle. Never refuel while smoking, or … Read more
The brake control system regulates hydraulic brake pressure for the front and rear wheels independently when the respective brake lever or brake pedal is applied and wheel lock is detected. There are two settings, BC1 and BC2. BC1 is standard ABS, which adjusts brake pressure based on vehicle speed and wheel speed data. BC1 is … Read more
Brake lever Distance Match mark Adjusting dial The brake lever is located on the right side of the handlebar. To apply the front brake, pull the lever toward the throttle grip. The brake lever is equipped with a brake lever position adjusting dial. To adjust the distance between the brake lever and the throttle … Read more