Yamaha YZ250F INSTRUMENT AND CONTROL FUNCTIONS

ENGINE STOP SWITCH

The engine stop switch “1” is located on the left handlebar. Continue pushing the engine stop switch till the engine comes to a stop.

The start switch “1” is located on the right handlebar. Push this switch to crank the engine with the starter.

The mode switch “1” is located on the left handlebar.

Press the mode switch to change between map 1 and map 2.

To change the mode

1.Shift to neutral.

2.Start the engine.

3.Press the mode switch.

As shipped from the factory, maps 1 and 2 are the same. You must use the Power Tuner app to adjust the map settings.

When the mode switch “1” is illuminated, map 2 is selected.

The shift pedal “1” has adopted a method of 1 down & 4 ups (press-down & kick-ups).

Press it down for N (neutral) to 1st, and kick it up for 2nd to 5th.

The front brake lever “1” is located on the right handlebar. Pull it toward the handlebar to activate the front brake.

The rear brake pedal “1” is in the right of the chassis. Press down on the brake pedal to activate the rear brake.

Starting a cold engine requires a larger amount of intake air, which is supplied by the starter knob “1”.

Pushing the knob toward “a” turns ON the starter, resulting in a larger angle of throttle valve.

: When operating the throttle grip in the closing direction, the starter knob “1” moves in the direction “b” as shown and returns to its original position.

: While handling the starter knob, take care not to burn yourself on exhaust pipes.

Fuel tank cap “1” is located under the fuel tank cap cover “2”.

Remove the fuel tank cap cover to open the fuel tank cap.

To remove the fuel tank cap cover, insert fingers under part “a”, and then use both hands to lift it up towards the rear of the vehicle.
Install the fuel tank cap cover after placing the bands “3” all the way in under the seat.